Porsche Enthusiasts Club Forum

Iv had Zola1 come round this evening (TOP BLOKE) and he tested the wire's etc and found them to be all ok tracked it down to the ECU so does anyone know were i can get mine repaired

JG911 wrote:Iv had Zola1 come round this evening (TOP BLOKE) and he tested the wire's etc and found them to be all ok tracked it down to the ECU so does anyone know were i can get mine repaired

I've had a PM conversation with Zola & suggested either BBA Reman or The ECU Doctor.

tr7v8 wrote:

JG911 wrote:Iv had Zola1 come round this evening (TOP BLOKE) and he tested the wire's etc and found them to be all ok tracked it down to the ECU so does anyone know were i can get mine repaired

I've had a PM conversation with Zola & suggested either BBA Reman or The ECU Doctor.

Yep the ECU Doctor has got it now

Got my ECU back this morning and iv connected it all up and still no joy of starting,all it does now is turns over then a pause then turns over then pause ...... any ideas

Hello Everyone,

Right a update for everyone.

Yesterday morning i had Derrick round again looking into this non start issue and after getting the ecu back from the doctor and getting some more advice from him and that great bloke Derrick on the job we got her started.

So in the end i replaced.

Battery.
Both Flywheel Sensors
DME Relays
Coil
Rotor Arm
Dizzy Cap
ECU Repaired
Fuses Repalced

And found it was a friend of a friend who took the rotor arm off pulled a little too hard and moved the dizzy and put the plugs a step out,so Derrick sorted that and now running as sweet as a nut ........

Think i did not help getting a number of people working on the car,all doing there bit then with Derrick having to back track all of it was not good ..... next time ill just stick to the same person DERRICK.

Glad you eventually got it sorted!!

I agree with you too many folks on the job usually makes for difficult times, stick with the one you have confidence with.......... it always works.

drive the car Hard and have fun.

Allan.

Good news that its running again

Thank god it is running this was beginning to become a drama longer than the Archers!
So was the ECU knackered or was it just the rotor positioning issue?

Jim it was both the Darlington transisters had packed up,and then the wrong firing order on the dizzy

JG911 wrote:Jim it was both the Darlington transisters had packed up,and then the wrong firing order on the dizzy

Umm which echoes what I say to everyone, don't go in haphazard be methodical & work through the possibilities. Otherwise it costs money & you can add to the problems rather than fix them.

Jim,

Derrick (Zola1) went back to the start and worked forward by checking and talking to friends who have worked on the 911 and get it going by eliminating as he/we went

Glad your running in time for Summer!! Wrong firing order! Actually easily done but it goes to show you can't trust the guy who went before you. Now you need to get out there & blow the cobwebs off it!

This true ill remember that for next time (hopeing there never is)

Yeh just need to MOT is now and TAX lol

Right here we go again

Thought id go start the 911 up let it run for a little bit then move out the garage turn round and put back in ...... but no engine runs sweet all oil pressures ok etc but when go to select a gear it a no go ... you can play a tune on it now .... think the clutch release bears has got stuck turned off and shut the garage door again

Check the hydraulics works first.

Try selecting first gear, foot depressed on the clutch and handbrake/footbrake fully on, and start it up, this often works on a stuck clutch.

If it stalls select reverse and try again, forward / reverse etc, until it frees up.

Be sure there are NO obstructions to the car's movement!! like your garage.